Multi-Purpose Fuse

by Jeff Lucius

These fuses are located to the left of the drivers feet. Empty fuse location #8 is a good location to temporarily tap into for +12V that is ignition switched (use the top slot). I use this location for my datalogger. For permanent gauges and controllers I tap into the wiring harness. Pulling the fuse at location #19 with the ignition turned off will reset the ECU and many other factory control units. Pulling the fuse at location #12 will disable the fuel pump and allow you to reduce fuel line pressure by turning the engine over (note that some pressure and fuel will remain in the lines).

Fuses  - decsription

Fuses - location

Mitsubishi 1991-1993 diagnostic connector M/T

Back Home Forward
Except for the small gif and jpg images, the content, images, photographs, text, and multimedia displayed are Copyright ©2000-2005 by Jeff Lucius and K2 Software. All rights reserved. No part, section, image, photo, article, or whole of this site may be reposted or redisplayed without permission of the author.
Page last updated April 17, 2005.