Check Connectors for the
Mitsubishi 3000GT VR4 and Dodge Stealth TT

by Jeff Lucius

With the ignition switch off and after removing the cap, insert a +12V jumper wire into the fuel pump check connector to supply current to the fuel pump.

After removing the cap, ground the ignition timing adjustment connector with a jumper wire to place the engine computer into "basic ignition timing" mode. Ground this connector and terminal 10 in the diagnostic connector (1991-1993 models) to put the engine computer into "basic idle speed adjustment" mode.

Insert a paper clip into the engine speed detection terminal to monitor the engine speed with a handheld tachometer. This terminal connects to one coil so the signal represents only 1/3 of the engine speed.


Back Home Forward
Except for the small gif and jpg images, the content, images, photographs, text, and multimedia displayed are Copyright ©2000-2003 by Jeff Lucius and K2 Software. All rights reserved. No part, section, image, photo, article, or whole of this site may be reposted or redisplayed without permission of the author.
Page last updated June 4, 2003.